Nothing is more frustrating than a water heater acting up on Sunday mornings. This is when you want to relax at home. What next? What's the next step? How do you find Water Heater Installation in San Diego? This article will help you to replace your old water heater by providing simple steps.
How to choose the right water heater
If the old one fails, you can find a replacement with the same fuel type, either propane, gas, or electric. Although you can choose a different size water heater if you want to replace it with a larger one, ensure enough room between the wall and the heater so that the water heater can fit.
Install the equipment
This guideline list can help you make important decisions when replacing your water heaters.
Check to plumb
Make sure that the heater you are replacing is the same size as the old one by measuring the distance between the hot and cold water pipes. It is much easier to measure before you start the replacement.
Water Heater Replacement can help you make it simpler. The gas union should be in the gas line if it's a gas heating unit. However, if it's water heating equipment, it must not. If not, you can cut the pipes from your old heater and place the cold water shutoff valve or hot water pipe union.
Installation
You will need two people to set the heater for the first time correctly. A rented appliance dolly is an economical way to save time and money, as the heater is quite heavy. Hire Water Heater Installation San Diego for all your needs.
Turn off all utilities
Please turn off all water utilities that are connected to the water heater, whether they are on electric or gas. Priority: Turn off the main water valve. If your electric water heater is on, turn off the electricity by removing the fuse or shutting off the circuit breaker.
If the tank is gas-powered, the gas cock will be located on the gas supply to the heater. If you have any doubts, turn the tank off and disconnect it from the gas supply line.
The hot water should be drained
After the water has been turned off, the fourth step is to drain all water from the tank. Open the hot water faucet, and connect a hose to drain the heater. Place the pipe or hose on the floor to drain the water and open the valve.
Disconnect the utility lines and remove and replace
Next, disconnect all utility lines. Once all modes have been disconnected, disconnect the flue from the heater. Then you can remove the old heater and install the new one. Clean the heater and place the new heater in the same spot. You can use a torpedo level to level the new water heater, so it is in the correct position.
As per your requirements, install fittings. Connect electric and gas pipes.
Attach the 3/4 copper flex lines to the old water heater's location with a helper's aid. Adjust the temperature to meet the specifications. Now, connect the gas or electric pipes to the heater. Use flexible copper supply cables if you cannot fix the inlet or outlet openings on the old heater.
To prevent electrolysis (an electro-galvanic reaction called electrolysis) from damaging your pipes and water heater connections, connect the pipes with the dielectric unions.
Conclusion
Attach the draft diverter to the flue if you fix a gas water heating system. Please read the heater installation guideline booklet. Fill the heater tank cold, then switch on the main gas. Next, light the pilot to heat the water. Get in touch with us for all your needs.
